Pancake Die Bracelet B001 Skinny Taper 5 3/4"

5 3/4" long, and tapered from 3/4" to 1 3/8" wide with squared edge. Use this with our bracelet former to make a bracelet. *** THIS DIE WILL NOT FIT IN A MEDIUM PRESS ***

Medium tapered bracelet 6" long, widest part 1 1/8" tapering down to 1/2 " This pattern has different sizes, great for layering! *** THIS DIE WILL NOT FIT IN A MEDIUM PRESS ***

6" long, tapered 7/8" to 1 3/4" wide. Square ends. Largest (length and width) of our bracelet dies. Use this bracelet die with any of our bracelet formers.rnSave a step when making a bracelet - just use a pancake die instead of sawing out the blank piece *** THIS DIE WILL NOT FIT IN A MEDIUM PRESS *** Outer Dimensions; 4 7/8" Tall x 8" Wide

Bracelet Die B001B Tapered Bracelet 6 1/2" x 1 1/4" *** THIS DIE WILL NOT FIT IN A MEDIUM PRESS ***

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.