Pancake Die Bracelet B019 Extra Skinny Taper 6 3/8"

Hand-carved by renowned engraver, Bill Rice, this extra-skinny version of his popular hummingbird design pairs well with pancake die B019. This listing is for one pattern plate; see the second photo for explanation of the three items in the photo. ~3/4" x 6" (18.5mm x 15.1cm)

Bracelet Die B001B Tapered Bracelet 6 1/2" x 1 1/4" *** THIS DIE WILL NOT FIT IN A MEDIUM PRESS ***

Medium tapered bracelet 6" long, widest part 1 1/8" tapering down to 1/2 " This pattern has different sizes, great for layering! *** THIS DIE WILL NOT FIT IN A MEDIUM PRESS ***

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

5 3/4" long and tapered from 5/8" to 1 1/6" wide with rounded ends. Use this to make a bracelet using our formers. *** THIS DIE WILL NOT FIT IN A MEDIUM PRESS ***

This spacer is 4.5'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.