Customers who bought this item also bought
Pancake Die Bracelet B002 Square Taper 5 3/4"
PD B002
5 3/4" long, and tapered from 3/4" to 1 3/8" wide with squared edge. Use this with our bracelet former to make a bracelet. *** THIS DIE WILL NOT FIT IN A MEDIUM PRESS ***
$44.25
Pancake Die Bracelet B001A Skinny Taper 6"
PD B001A
Medium tapered bracelet 6" long, widest part 1 1/8" tapering down to 1/2 " This pattern has different sizes, great for layering! *** THIS DIE WILL NOT FIT IN A MEDIUM PRESS ***
$44.25
Pancake Die Bracelet B001 Skinny Taper 5 3/4"
PD B001
5 3/4" long and tapered from 5/8" to 1 1/6" wide with rounded ends. Use this to make a bracelet using our formers. *** THIS DIE WILL NOT FIT IN A MEDIUM PRESS ***
$44.25
Aluminum Spacer (4.5” x 7.75” x 1”)
Al-Spacer
This spacer is 4.5'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.
$34.75
Urethane Pieces
UP
Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.
$8.50
Pancake Die Bracelet B002B Square Taper 6 1/2"
PD B002B
Bracelet Die B002B 6 1/2" long x 1 9/16" widest *** THIS DIE WILL NOT FIT IN A MEDIUM PRESS *** Outer Dimensions; 5 3/16" Tall x 7 1/4" Wide
$44.25