Pancake Die Bracelet Die B001B Skinny Taper 6 1/2"

Enjoy William Rice's engraving of his iconic hummingbird --- fit for Pancake Die B001 B! Measures at 1 1/4" x 6 3/8" or 32mm x 165mm Plate Thickness: ~2.5mm. Customer demo: Melany Luna Sarafis

Medium tapered bracelet 6" long, widest part 1 1/8" tapering down to 1/2 " This pattern has different sizes, great for layering! *** THIS DIE WILL NOT FIT IN A MEDIUM PRESS ***

Bracelet Die B002B 6 1/2" long x 1 9/16" widest *** THIS DIE WILL NOT FIT IN A MEDIUM PRESS *** Outer Dimensions; 5 3/16" Tall x 7 1/4" Wide

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

This spacer is 4.5'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.

Bracelet Die B019 Extra Skinny Taper 6 3/8" x 7/8" widest point ***Will not fit in the discontinued Potter USA medium press***