Stylized Holly Pendant and Earrings Bundle

Just add leather! This bundle includes all the tools you need to make this panel bracelet. Includes: PD1837: 2" x 1/2" (50 x 13mm). Die 4" x 5" (100 x 128mm.) RMP393: 2" x 6.5". Impression die BR-RT314: 12 x 8.7mm. Download the instructions below!

This bezel die tool will create as many 8mm round bezels as you'd like to press in your hydraulic press. Recommended for 22 ga. nonferrous metal. The size of disc you start with for the 8mm bezel die is a 1/2" disc. The interior bezel height after pressing is ~3mm. You can adjust the height to fit your specific stone.

This spacer is 4.5'' x 7.75'' and 1'' thick.

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

This bezel die tool will create as many 10mm round bezels as you'd like to press in your hydraulic press. Recommended for 20 ga. nonferrous metal. The size of disc you start with for the 10mm bezel die is a 5/8" disc. The interior bezel height after pressing is ~3.5mm. You can adjust the height to foot your specific stone.

This bezel die tool will create as many 12mm round bezels as you'd like to press in your hydraulic press. Recommended for 20 ga. nonferrous metal. The size of disc you start with for the 12mm bezel die is a 3/4" disc. The interior bezel height after pressing is ~3.5mm. You can adjust the height to fit your specific stone.