Panel Bracelet Bundle

This spacer is 4.5'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.

This bezel die tool will create as many 10mm round bezels as you'd like to press in your hydraulic press. Recommended for 20 ga. nonferrous metal. The size of disc you start with for the 10mm bezel die is a 5/8" disc. The interior bezel height after pressing is ~3.5mm. You can adjust the height to foot your specific stone.

This bezel die tool will create as many 6mm round bezels as you'd like to press in your hydraulic press. Recommended for 22 ga. fine silver. The size of disc you start with for the 6mm bezel die is a 12mm disc. The interior bezel height after pressing is ~3mm. You can adjust the height to fit your specific stone.

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.