Pancake Die B036 Circles Bracelet

This spacer is 4.5'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

Bracelet Die B001B Tapered Bracelet 6 1/2" x 1 1/4" *** THIS DIE WILL NOT FIT IN A MEDIUM PRESS ***

Bracelet Die B019 Extra Skinny Taper 6 3/8" x 7/8" widest point ***Will not fit in the discontinued Potter USA medium press***

Design your own impression die! Made with special die-carving steel that is easy to carve. Use files, gravers, burs, or chasing tools to carve your own design in the negative.