Pancake Die 1515 3.5" Oval

Brand new! Use this tool to make shallow domed forms, such as trinket dishes, lockets, small containers, etc. 3" x 2" oval 1/4" thick. Must be used with a large sheet of urethane (available separately).

For use only with Dish Former Silhouette Dies. ~4.75" x 4.75" 60-70 durometer. Color may vary. 1/4" thick.

This spacer is 4.5'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.

Design: 3-3/4" x 2-3/4" Die itself: 7" x 5-1/2" Coordinated to work with the Oval Dish former die DF-006

An assortment of 10 small pieces of aluminum (sizes vary) that can be used to create a force when pressing impression dies. Sizes will vary from 1/2" - 1". Forces work best when the aluminum is pressed hot. ALWAYS CENTER YOUR WORK. Watch the following videos to see Kevin demonstrating how these work: https://www.facebook.com/groups/1253577991351417/?multi_permalinks=7886112968097853&ref=share AND https://www.facebook.com/1640860751/videos/807686980360120/

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.