Urethane Sheet for Dish Former Silhouette Dies

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

This spacer is 4.5'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.

Brand new! Use this tool to make shallow domed forms, such as trinket dishes, lockets, small containers, etc. 3" x 3" Square with Slightly Rounded Edges 1/4" thick. Must be used with a large sheet of urethane (available separately). ***Will not fit in the discontinued Potter USA medium press***

Brand new! Use this tool to make shallow domed forms, such as trinket dishes, lockets, small containers, etc. 3" from point to center of opposite edge. ~2-15/16" from point to point. 1/4" thick. Must be used with a large sheet of urethane (available separately).

Brand new! Use this tool to make shallow domed forms, such as trinket dishes, lockets, small containers, etc. 2-1/2" diameter. 1/4" thick. Must be used with a large sheet of urethane (available separately). Pairs well with PD661A

Brand new! Use this tool to make shallow domed forms, such as trinket dishes, lockets, small containers, etc. 1-1/2" x 2-1/2" Oval 1/4" thick. Must be used with a large sheet of urethane (available separately).