Customers who bought this item also bought
Aluminum Spacer (4.5” x 7.75” x 1”)
Al-Spacer
This spacer is 4.5'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.
$34.75
Urethane Pieces
UP
Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.
$8.50
2" Magnetic Tool Steel Pusher
Pusher-1
Tool Steel Magnetic Pusher to be used on impression dies in a hydraulic press. 2" diameter. Approx. 3/4" tall, including 1/4" tool steel face. Attaches to upper platen with a magnet.
$35.00
Tool Steel Magnetic Ring Pusher
Pusher 2 - Ring
This tool steel ring pusher will give you greater detail in your rings when used on impression dies in a hydraulic press. Size: 3" x 1-1/2"
$45.00
Aluminum Spacer (4.5" x 7.75"x1/2")
Al-SpacerThin
This spacer measures 7-3/4" in length, 4-1/2" in width, and is 1/2" thick. It is nonmagnetic. Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.
$21.50
Urethane Sheet for Dish Former Silhouette Dies
DFUrethane
For use only with Dish Former Silhouette Dies. ~4.75" x 4.75" 60-70 durometer. Color may vary. 1/4" thick.
$20.00