Impression Die Royal Navy Commander 1780's

This spacer is 6''  x  8''  and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use metal pieces on lower platen to take up space between platens.

Bracelet Die B001B Tapered Bracelet 6 1/2" x 1 1/4" *** THIS DIE WILL NOT FIT IN A MEDIUM PRESS ***

Bracelet Die B002B 6 1/2" long x 1 9/16" widest  *** THIS DIE WILL NOT FIT IN A MEDIUM PRESS ***

Bracelet Die B019 Extra Skinny Taper 6 3/8" x 7/8" widest point *** THIS DIE WILL FIT IN A MEDIUM PRESS ***

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch to 1 inch in length. Thickness of each piece is 1/4 inch.  Note: These will fray, crack and deform with use, but you will get many uses from them.