Pancake Die OCT317A Fall Leaf

20 gauge copper sheet with 25 pre-cut leaf shapes. Each shape is is 1-1/16" x 1". Shapes are cut leaving two 1mm tabs. Each shape easily twists out of the sheet. Each sheet may come with some surface scratches and discoloration on the copper. Cutouts will have a slight raised bur on the reverse side.

This die is to make a ring shank that then has a 16mm circle opening to place a stone and bezel. At longest tips it is 3 1/8". Skinniest point is 1/4" H, and tallest points (at ends) is 1 1/4" High.

An assortment of 10 small pieces of aluminum (sizes vary) that can be used to create a force when pressing impression dies. Sizes will vary from 1/2" - 1". Forces work best when the aluminum is pressed hot. ALWAYS CENTER YOUR WORK. Watch the following videos to see Kevin demonstrating how these work: https://www.facebook.com/groups/1253577991351417/?multi_permalinks=7886112968097853&ref=share AND https://www.facebook.com/1640860751/videos/807686980360120/