GRS Holder Sale

Design: 1-5/8" x 5-3/8" Plate Thickness: ~2.5mm

Mandrel not included. Does NOT include base! Must be used with GRS. This will hold a standard 1 inch ring mandrel!

This die measures 1" tall x 5/8" wide. This die must be used in a hydraulic press.

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch.  Note: These will fray, crack and deform with use, but you will get many uses from them.

This ring is 3" long and 2" at its widest point in the center. This die must be used in a hydraulic press. Customer demo: Piper Lane Davis **FORMALLY R1200**