Coil Cutter Blade .012 thickness

This Coil Cutter Kit is for use with a DREMEL only. See below for specifics. Kit includes: Aluminum 6" long coil holder block and steel top plate for holder; Saw blade, guard for Dremel with adapter bushing, 1 saw arbor to fit 3/8" hole blades. Coils to be cut can be up to 4 inches long and 7/8 inch (22 mm) in outside diameter. Coils may be made of 12 through 30 gauge wire. (NOTE: Does not fit battery-powered, cordless or very old Dremels). We use a Dremel 200 here in our shop.

Use this for winding the wire to make the jumprings. Ships in a medium US Flat rate box.

Metric mandrels from 1mm to 13 mm Mandrels are transfer punch sets. You can purchase transfer punch sets elsewhere if necessary, we offer it as a service so you can get everything at one place. NOTE: Current mandrels don't include notches at base. Simply insert your wire into the chuck with the mandrel, and make sure the wire is secured in the jaws before winding. The notch isn't necessary.

This Coil Cutter Kit is for use with a #30 Foredom flex shaft handpiece only. Kit includes: Aluminum 6" long coil holder block and steel top plate for holder; Saw blade, guard for Foredom #30 Flexshaft handpiece with adapter bushing, 1 saw arbor to fit 3/8" hole blades. Coils to be cut can be up to 4 inches long and 7/8 inch (22 mm) in outside diameter. Coils may be made of 12 through 30 gauge wire.

Set 28 of mandrels. Sizes range from 3/32" to 1/2" by 64ths of an inch. NOTE: Current mandrels don't include notches at base. Simply insert your wire into the chuck with the mandrel, and make sure the wire is secured in the jaws before winding. The notch isn't necessary.