Customers who bought this item also bought
Coil Cutter Blade .012 thickness
Blade
U.S. made blades, not import. 3/8" hole, 1 1/4" diameter, 120 teeth .012" is the thickness/width of the blade.
$17.50
Coil Cutter - Winder
CC Winder
Use this for winding the wire to make the jumprings. Ships in a medium US Flat rate box.
$50.00
Coil Cutter - Metric Mandrel Set
CC Metric
Metric mandrels from 1mm to 13 mm Mandrels are transfer punch sets. You can purchase transfer punch sets elsewhere if necessary, we offer it as a service so you can get everything at one place. NOTE: Current mandrels don't include notches at base. Simply insert your wire into the chuck with the mandrel, and make sure the wire is secured in the jaws before winding. The notch isn't necessary.
$34.00
Coil Cutter Mandrel Set - English measurement
CC Mandrels
Set 28 of mandrels. Sizes range from 3/32" to 1/2" by 64ths of an inch. NOTE: Current mandrels don't include notches at base. Simply insert your wire into the chuck with the mandrel, and make sure the wire is secured in the jaws before winding. The notch isn't necessary.
$23.00
Urethane Pieces
UP
Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.
$8.50
Aluminum Spacer (4.5” x 7.75” x 1”)
Al-Spacer
This spacer is 4.5'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.
$34.75