Pattern Plate RMP018 Skeleton Leaves 1

Designed to be used in a rolling mill with annealed, non-ferrous metal.

Plate Size: ~7" L x 2" W
Plate Thickness: ~2.5mm
Leaf 1: 1-1/2" x 2-1/2"
Leaf 2: 1-1/2" x 2"
Leaf 3:  1-1/2" x 2-1/2"

The plate may be slightly curved when it arrives, and that’s okay! It will not harm your rolling mill, as the plates will curve with use anyway. The metal used for the plate is softer than the rolls of a rolling mill and will not damage them. It is also safe to use in a press.

NOTE: It is possible to use these rolling mill plates with a hydraulic press, but the results won’t be the same as with the rolling mill; we only recommend a rolling mill. If using a press, use a single, small piece of urethane and press multiple times; you'll only be able to get a small section of the design at a time.