This die measures 4-1/2" x 4-1/2". The design measures 1-5/8" x 1/2" but will cut a progressive strip as long as you want.

***THIS DIE IS TOO LARGE FOR THE MINI PRESS*** Long Scallop Ring Band 3 9/16" x 1/2". Customer demo: Linda Searcy

Cigar Ring Band 2 7/16" long 3/4" widest width and tapers down to 7/16" on both ends.

1/2"x3"

Design: 1-1/8" x 3". Die: 5-1/2" x 4-15/16".

Pancake Die R008 Feather Wrap Around Ring Band 3 1/4" long

This die must be used in a hydraulic press. 3-5/8" x 1-1/16"

7/8" H (at highest point) x 3 3/8" W Narrowest point is 1/8"

1/2" x 3"

Ring is 3 inches wide (long) x .25" thick band with oval section is 1" thick.

Pancake Die 702A Cigar Ring Band 2 1/2" long x 5/8" wide

Design: 1-11/16" x 3". Die: 5-5/8" x 4-15/16".

Pancake Die R001 Ring/Bail 2 1/2" long 1/2" widest point

This die measures 4-1/2" x 4-1/2". The design measures 1-1/2" x 9/16" but will cut a progressive strip as long as you want.

3/4" x 3-3/8"

This die is to make a ring shank that then has a 16mm circle opening to place a stone and bezel. At longest tips it is 3 1/8". Skinniest point is 1/4" H, and tallest points (at ends) is 1 1/4" High.

7/8"H x 3 1/4"W or 22.2mm x 82.5mm

This die measures 3 3/4" long x 1/4" wide

1 1/8"H x 3 9/16"W or 28.6mm x 90.5mm

7/8" x 3 1/2" or 22mm x 89mm

1/4" x 3 5/8"

This ring is 3" long and 2" at its widest point in the center. This die must be used in a hydraulic press. Customer demo: Piper Lane Davis **FORMERLY R1200**