Pattern Plate RMP247 The Birds

Overall Design Size: approximately 2" x 6-7/8". Designed for use in a rolling mill.

This spacer measures 7-3/4" in length, 4-1/2" in width, and is 1/2" thick. It is nonmagnetic. Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.

Overall Design Size: approximately 2" x 6-7/8". Designed for use in a rolling mill.

9/16" x 1/2" Sample jewelry made by Jolé Danae Moon. NOTE: We had to make a copy of the original hub, and by the nature of the reproduction process, the front lip of the mushroom does not have as much texture as the original hub. This is an artifact of the process and is not considered a defect. NOTE: Because of the front lip of the mushroom, your metal may stick in the die more than others. Always leave a small lip around the impression to assist when removing your metal. For best results, lightly oil the impression die to make removing your metal easier.

This spacer is 4.5'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.

Design Size: approximately 2" x 6-7/8" Designed for use in a rolling mill.