Pancake & Silhouette Die Bundle: Wonky Heart

Approx. 16 gauge (Due to supply challenges, gauge may vary.) Design: 1” x 3/4” NOTE: Each stamping is made in house, one at a time, using vintage tools and processes. The detail in each stamping may vary, and a stamping with less detail is not considered defective.

Design: 11 x 7.5mm each. Die: 2-3/8" x 4-5/8". Designed to work with the Tortolita and Rincon presses!

This kit includes 5 pancake dies which work together to form a 1" round lidded container. Use this pancake die set with 18-gauge sheet metal to create 1" round boxes with fitted lids! The kit includes pancake dies for two types of lids - over-fitted lids (lids that fit over the container), and inside-fitted lids (lids that have an inner rim that fits down into the container). These small containers are perfect for ring boxes, little gifts, small treasures, pill boxes, or whatever you can think of! We’ve done all the math for you so you don’t have to figure out how to make all the parts fit together yourself - just cut, solder, form, and assemble! **The die measurements have all been done for 18 gauge metal and a snug fitted lid. You can use other gauges (16-22) but it will change the fit of the lid and container. This set includes the following: PD1913: Container body measures 83mm x 20mm, overall die measures 5-3/8" x 5-5/16" PD1914: Over-Fitted Lid measures 91mm x 10mm, overall die measures 5-7/16" x 4-15/16" PD1915: Inside-Fitted Lid Outer Band measures 83mm x 10mm, overall die measures 5-7/16" x 4-15/16" PD1916: Inside-Fitted Lid Inner Band measures 77mm x 10mm, overall die measures 5-7/16" x 4-15/16" PD1917: Lid top and container bottom measures 28mm diameter, overall die measures 3-3/8" x 5-5/8"

The Standard Die Shoe is more durable and will last longer than the High-production Die Shoe, due to the smaller size of the hole in the base offering more support to the Die Sets (available separately). Standard Die Shoe OR High-production Die Shoe REQUIRED FOR ALL FSS DIE SETS (available separately)! Die Shoes are interchangeable with different FSS Die Sets. Interchangeable FSS Standard Die Shoe Includes: Base with two sizes of pins to maintain correct indexing and assembly and center hole to assist with metal alignment and for removing cut blanks. Aluminum Pusher Plate with two oversized holes Two springs to place between the top and bottom of the Die Sets (Die Sets available separately) Watch Kevin demonstrate how to use this die: https://youtu.be/7Gl-ShVKtlk

Design: 15/16" x 5/8" Die Set Includes: Die Top, with precision-welded cutter Die Bottom, with precision-registered center hole and metal guide marks on bottom- and right-side edges to assist in lining up metal in the die Urethane: Specific to each die set; not interchangeable with other designs. Color may vary. The components of each Die set are not interchangeable with other die sets, but all can be used with a single, standard Die Shoe. MUST BE USED WITH THE FSS DIE SHOE (available separately) Watch Kevin demonstrate how to use this die: https://youtu.be/7Gl-ShVKtlk