Customers who bought this item also bought
Urethane Pieces
UP
Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.
$8.50
Aluminum Spacer (4.5” x 7.75” x 1”)
Al-Spacer
This spacer is 4.5'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.
$39.75
2 x 2 Contained Urethane with Pusher
2 x 2 Contained Urethane
2" x 2" contained urethane with pusher for use with our standard, 2" silhouette dies. Kit includes: container, 95 durometer urethane, metal pusher (silhouette dies sold separately). NOT for use with impression dies.
$62.75
Pattern Plate RMP215 Shibori
RMP215
Design Size: approximately 2" x 6-7/8". Designed for use in a rolling mill. Sample earrings made by Erin Greenberg (shibori plate and the large guitar pick pancake and silhouette die bundle) https://potterusa.com/pancake-silhouette-die-bundle-large-guitar-pick
$39.00
FSS (Fast Stamping System) High-production Die Shoe
FSS-HPDieShoe
The High-production Die Shoe features a large well in the base to allow for cut blanks to fall out of the bottom of the assembly. NOTE: This High-production Die Shoe base is more delicate than the Standard Die Shoe base and is more prone to damage when over-pressed. Please read ALL instructions before use to learn how to avoid over-pressing. The max gauge for use with the High-production Die Shoe that we recommend is 16 gauge. Opening in base is 1 7/8" x 1 7/8" Standard Die Shoe OR High-production Die Shoe REQUIRED FOR ALL FSS DIE SETS (available separately)! Base is interchangeable with different FSS Die Sets. Interchangeable FSS High-production Die Shoe Includes: Base with two sizes of pins to maintain correct indexing and assembly and large center hole to assist with metal alignment and for collecting and removing cut blanks. Aluminum Pusher Plate with two oversized holes Two springs to place between the top and bottom of the Die Sets (Die Sets available separately) Watch Kevin demonstrate how to use this die: https://youtu.be/7Gl-ShVKtlk
$35.00