Pancake & Silhouette Die Bundle: Cherry Blossom

This spacer is 4.5'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.

2" x 2" contained urethane with pusher for use with our standard, 2" silhouette dies. Kit includes: container, 95 durometer urethane, metal pusher (silhouette dies sold separately). NOT for use with impression dies.

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

Pancake Die Opener

Design: 1-1/2" diameter Circle Die Set Includes: Die Top, with precision-welded cutter Die Bottom, with precision-registered center hole and metal guide marks on bottom- and right-side edges to assist in lining up metal in the die Urethane: Specific to each die set; not interchangeable with other designs. Color may vary. The components of each Die set are not interchangeable with other die sets, but all can be used with a single, standard Die Shoe. MUST BE USED WITH THE FSS DIE SHOE (available separately) Watch Kevin demonstrate how to use this die: https://youtu.be/7Gl-ShVKtlk

3 inch diameter x 2 inch height contained urethane with metal pusher (pusher not pictured). Comes with 95 durometer urethane. ***You can use this with 2 inch silhouette dies, BUT, the impression will not be able to get as deep as with the 2 x 2 contained urethane. NOT for use with impression dies.