Pancake Die Large Asymmetrical Rounded Triangle

This spacer is 4.5'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.

Pancake Die Opener

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

Designed for use in a rolling mill; will also work in a 20-ton press 2" x ~8" Plate Thickness: ~2.5mm

Our redesigned pancake dies are here! Pick: 1" wide x 1 1/8" long

This listing is for one pattern plate; see the second photo for explanation of the three items in the photo. Each Ring Design is : 2 7/8" long x 3/8" wide