Pancake Die Bracelet B038 Feather 1

This plate is designed to be used in a rolling mill with annealed, non-ferrous metal. Plate Size: ~7" L x 2" W Plate Thickness: ~2.5mm Design Size: 5-7/16" L x 1-1/4" W

This spacer is 4.5'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.

Copper Sheet 18 Gauge 5" x8". Fully hard CDA # 110; 99.9% PURE.

This bezel die tool will create as many 10mm round bezels as you'd like to press in your hydraulic press. Recommended for 20 ga. nonferrous metal. The size of disc you start with for the 10mm bezel die is a 5/8" disc. The interior bezel height after pressing is ~3.5mm. You can adjust the height to foot your specific stone.

Design: 1 1/8"H x 5 9/32"W. Die itself: 4 7/16"H x 6 13/16"W. Use die sideways in press with extended platens or press about 1/2 the die at a time.

7/8"H x 1 11/16"W