Pancake Die Amparo's Gecko

This spacer is 4.5'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.

Pancake Die Opener

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

This spacer measures 7-3/4" in length, 4-1/2" in width, and is 1/2" thick. It is nonmagnetic. Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.

Design Size: 2" x ~6-3/16". Each strip of pattern is approximately 3/8" wide. Sample jewelry made by Jolé Danae Moon. This pattern can be used to make individual jewelry pieces like earrings and cuff links, as well as embellishments for other pieces.

Tool Steel Magnetic Pusher to be used on impression dies in a hydraulic press. 2" diameter. Approx. 3/4" tall, including 1/4" tool steel face. Attaches to upper platen with a magnet.