Pancake Die 1821 Saloon Plaque

Design: 1-1/4" x 1-3/4". Die: 5-5/8" x 3-11/16".

This bezel die tool will create as many 8mm round bezels as you'd like to press in your hydraulic press. Recommended for 22 ga. nonferrous metal. The size of disc you start with for the 8mm bezel die is a 1/2" disc. The interior bezel height after pressing is ~3mm. You can adjust the height to fit your specific stone.

Design: 1-3/16" (30.7mm) Rounded Square Die Set Includes: Die Top, with precision-welded cutter Die Bottom, with precision-registered center hole and metal guide marks on bottom- and right-side edges to assist in lining up metal in the die Urethane: Specific to each die set; not interchangeable with other designs. Color may vary. The components of each Die set are not interchangeable with other die sets, but all can be used with a single, standard Die Shoe. MUST BE USED WITH THE FSS DIE SHOE (available separately) Watch Kevin demonstrate how to use this die: https://youtu.be/7Gl-ShVKtlk

Design: 2-3/8" wide from edge to edge. Overall die size is 7-1/4" x 5". ***Will not fit in the discontinued medium PotterUSA press***

Design: 2" wide from edge to edge. Overall die size is 6-13/16" x 4-7/16".

Design Size: approximately 2" x 6-7/8". Designed for use in a rolling mill.