Close
(0) items
You have no items in your shopping cart.
All Categories
    Filters
    Preferences
    Search

    Pancake Die 1339 Banana Leaf Small

    $27.50
    This small banana leaf design will give your jewelry a tropical feel. Design: 1"W x 1/2"H or 25mm x 13mm
    SKU: PD 1339
    Availability: 3 in stock

    Design: 1"W x 1/2"H or 25mm x 13mm

    • Designed for use in a 20-ton hydraulic press
    • Use ONLY with full-hard, non-ferrous metal (do NOT anneal your metal)
    • Acceptable gauges: 16-22 gauge
    • Cutting edges are straight, not at an angle
    • Shipped pre-sprung

    Design: 1"W x 1/2"H or 25mm x 13mm

    • Designed for use in a 20-ton hydraulic press
    • Use ONLY with full-hard, non-ferrous metal (do NOT anneal your metal)
    • Acceptable gauges: 16-22 gauge
    • Cutting edges are straight, not at an angle
    • Shipped pre-sprung
    Customers who bought this item also bought

    Nouveau Fields Copper 1ft Wire CFW049

    $11.00
    1.5"W x 1ft

    Pancake Die 833A Cherry Blossom

    $27.50
    This cherry blossom pancake die is perfect for the spring season. Design: 1 1/4" diameter

    Pancake Die R112 Angled Ring Band 3 3/8"

    $27.50
    Pancake Die R112 Angled Ring Band 3 3/8" long,  wide end 1",  narrrow end 1/4""

    Out of stock

    Urethane Pieces

    $8.50
    Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch.  Note: These will fray, crack and deform with use, but you will get many uses from them.

    6 x 8 Aluminum Spacer

    $34.75
    This spacer is 6''  x  8''  and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use metal pieces on lower platen to take up space between platens.

    Out of stock