Pancake Die 1216A Medium Kokopelli

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch to 1 inch in length. Thickness of each piece is 1/4 inch.  Note: These will fray, crack and deform with use, but you will get many uses from them.

This die must be used in a hydraulic press. This die measures 15/16" around

1/2" W x 5/8" H or 13mm x 16mm

This die is to make a ring shank that then has a 16mm circle opening to place a stone and bezel. At longest tips it is 3 1/8". Skinniest point is 1/4" H, and tallest points (at ends) is 1 1/4" High.

1" x 1 5/8" or 25mm x 41mm