Moire Pattern Copper Patterned Sheet- CFW085

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

This spacer is 4.5'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.

Design Size: 1-5/8" x 6-11/16"; ~1/8" thick

We have a limited quantity of these larger wing nuts that may make loosening and tightening your saw blade in the frame easier! Their large size is helpful to those with mobility and/or grip strength issues. Sold in a set of two. No restocks. 16.9 x 36mm each

Hand-carved by renowned engraver, Bill Rice, this extra-skinny version of his popular hummingbird design pairs well with pancake die B019. This listing is for one pattern plate; see the second photo for explanation of the three items in the photo. ~3/4" x 6" (18.5mm x 15.1cm)