Pancake Die 1219 Arabesque Festoon 1

Our redesigned pancake dies are here! Design: 1"H x 1-1/4"W Designed by Gina Copanzzi

Design: 1-1/4"W x 1" Designed by Gina Copanzzi

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

This spacer is 4.5'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.

This die must be used in a hydraulic press. This die measures 1 1/2" wide x 1 3/16" tall