DISCONTINUED**Do no re-publish** Hand Hammered RMP068

Design: 1-5/8" x 5-3/8" Plate Thickness: ~2.5mm

Design: 7/8" x 7" Plate Thickness: ~2.5mm

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

Design: 2" x 7" Plate Thickness: ~2.5mm

Designed to be used in a rolling mill with annealed, non-ferrous metal. Plate Size: ~7" L x 2" W Plate Thickness: ~2.5mm The plate may be slightly curved when it arrives, and that’s okay! It will not harm your rolling mill, as the plates will curve with use anyway. The metal used for the plate is softer than the rolls of a rolling mill and will not damage them. It is also safe to use in a press.