Sorry - this product is no longer available

DISCONTINUED Copper Pop-Out Blanks 1/2" Fall Leaf A 20 Gauge

20 gauge copper sheet with 25 pre-cut leaf shapes. Each shape is is 1/2" x 1/2". Shapes are cut leaving two 1mm tabs. Each shape easily twists out of the sheet. Each sheet may come with some surface scratches and discoloration on the copper. Cutouts will have a slight raised bur on the reverse side.
SKU: CP20G-005-A

20 gauge copper sheet with 25 pre-cut leaf shapes.  Each shape is is 1/2" x 1/2".  Shapes are cut  leaving two 1mm tabs.  Each shape easily twists out of the sheet.  
Each sheet may come with some surface scratches and discoloration on the copper.  Cutouts will have a slight raised bur on the reverse side.

$12.95
increase decrease
Availability: In stock
Ship to
*
*
Shipping Method
Name
Estimated Delivery
Price
No shipping options

20 gauge copper sheet with 25 pre-cut leaf shapes.  Each shape is is 1/2" x 1/2".  Shapes are cut  leaving two 1mm tabs.  Each shape easily twists out of the sheet.  
Each sheet may come with some surface scratches and discoloration on the copper.  Cutouts will have a slight raised bur on the reverse side.

Customers who bought this item also bought

Copper Sheet 18 Gauge 5" x 8"

CS 18
Copper Sheet 18 Gauge 5" x8". Fully hard CDA # 110; 99.9% PURE.
$15.00

Urethane Pieces

UP
Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.
$8.50

Aluminum Spacer (4.5" x 7.75"x1/2")

Al-SpacerThin
This spacer measures 7-3/4" in length, 4-1/2" in width, and is 1/2" thick. It is nonmagnetic. Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.
$28.50

Pattern Plate RMP260 Scattered Suns

RMP260
Overall Design Size: approximately 2" x 6-7/8". Designed for use in a rolling mill.
$39.00

Copper Sheet 20 Gauge 5" x 8"

CS 20
Plain copper sheet, 20 gauge. 5 inch x 8 inch piece CDA #110; 99.9% pure
$14.00

Aluminum Spacer (4.5” x 7.75” x 1”)

Al-Spacer
This spacer is 4.5'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.
$39.75