(0) items
You have no items in your shopping cart.
All Categories

    Impression Die Brick Bar

    1 1/2" x 7/16" or 38mm x 11mm
    SKU: P027
    Availability: In stock

    1 1/2" x 7/16" or 38mm x 11mm

    1 1/2" x 7/16" or 38mm x 11mm

    Customers who bought this item also bought

    Impression Die Art Nouveau Swirl Pin

    This die must be used in a hydraulic press This die measures 1 3/8" wide  X  1/4" tall

    Urethane Pieces

    Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch to 1 inch in length. Thickness of each piece is 1/4 inch.  Note: These will fray, crack and deform with use, but you will get many uses from them.

    6 x 8 Aluminum Spacer

    This spacer is 6''  x  8''  and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use metal pieces on lower platen to take up space between platens.

    Out of stock

    Tool Steel Pusher

    This is a tool steel pusher used with impression dies and pattern bars.

    Impression Die Roped Button

    3/4" in diameter or 19mm x 19mm