Pancake Die 1210 Earring Back

$27.50

5/16" x 13/16" PLEASE READ: Don't use metal thinner than 22 gauge! Metal must be full hard. There are no instructions, but there are a couple tips, below.

SKU: PD 1210

Ship to

Shipping Method

Name

Estimated Delivery

Price

No shipping options

Availability: In stock

Qty:

Overview

5/16" x 13/16"
PLEASE READ: Don't use metal thinner than 22 gauge! Metal must be full hard. Don't anneal your metal after cutting the blank. Drill a hole at the center just slightly larger than your earring post. Make sure your ear wire has a groove in it...the wings of ear nuts are what keep them secured onto the post, not the hole in the center.

Customers who bought this item also bought

Impression Die Blank Puck

Blank ID

$13.50

Design your own impression die! Made with special die-carving steel that is easy to carve. Use files, gravers, burs, or chasing tools to carve your own design in the negative.

Aluminum Spacer (4.5” x 7.75” x 1”)

Al-Spacer

$34.75

This spacer is 4.5'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.

Pancake Die Opener

PDopener

$14.00

Pancake Die Opener

Urethane Pieces

$8.50

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.