Close
(0) items
You have no items in your shopping cart.
All Categories
    Filters
    Preferences
    Search

    Pancake Die B029 7 Quatrefoil Bracelet

    $44.25
    15/16" H (just under an inch) x 6"W  Each quatrefoil section is 15/16"H x 7/8"W.  Die itself is 5" H x 9"W. Die must be used sideways in press (perpendicular to press) with extended platens, or put in 1/2 way (perpendicular), pressed, and then the other 1/2 put in and pressed.
    SKU: PD B029
    Availability: In stock

    15/16" H (just under an inch) x 6"W  Each quatrefoil section is 15/16"H x 7/8"W.  Die itself is 5" H x 9"W.

    Die must be used sideways in press (perpendicular to press) with extended platens, or put in 1/2 way (perpendicular), pressed, and then the other 1/2 put in and pressed.

    15/16" H (just under an inch) x 6"W  Each quatrefoil section is 15/16"H x 7/8"W.  Die itself is 5" H x 9"W.

    Die must be used sideways in press (perpendicular to press) with extended platens, or put in 1/2 way (perpendicular), pressed, and then the other 1/2 put in and pressed.

    Customers who bought this item also bought

    Urethane Pieces

    $8.50
    Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch to 1 inch in length. Thickness of each piece is 1/4 inch.  Note: These will fray, crack and deform with use, but you will get many uses from them.

    Out of stock

    Pancake Die B030 Feather Bracelet Oval center

    $44.25
    1.25"H (in center) x 6.5"W  Feather portions are approx 3/4" H x 3 3/4" W (per feather). Center oval is 1.25" H x 15/16" W  Die itself is 5 5/16" H x 9.5" W. Must be used sideways in press (perpendicular to press) with extended platens or put in 1/2 way and cut and moved over to cut other 1/2. Customer demo: Melissa Reichert-Leyland

    LAST CALL! Bracelet Die B006A Wave 6"

    $35.40 $44.25
    Wave Bracelet 6" long x 5/8" wide Fits in a medium press

    Out of stock

    LAST CALL! Pancake Die 1198 Corn Maiden

    $22.00 $27.50
    This corn maiden design is used to cut metal blanks in a hydraulic press. Design: 7/8" wide x 2 1/8" long

    6 x 8 Aluminum Spacer

    $34.75
    This spacer is 6''  x  8''  and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use metal pieces on lower platen to take up space between platens.