Customers who bought this item also bought
Urethane Pieces
UP
Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.
$8.50
Pancake Die 831.3 Large Sea Turtle
PD 831.3
This die must be used in a hydraulic press. This die measures 1-1/2" wide x 1-1/2" tall
$27.50
Frank Morrow Pattern A Copper Strip CFW031
CFW031
3/4" wide 16-gauge cut into just over 1 foot lengths
$20.00
Aluminum Spacer (4.5” x 7.75” x 1”)
Al-Spacer
This spacer is 4.5'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.
$39.75