Flat Bracelet Former Set Lg/Sm

This spacer is 4.5'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

3 inch diameter x 1 inch thick, 90/95 durometer urethane insert. Can be used with or without a container. If over-squeezed without a container, it will crack. COLOR WILL VARY.

This is a ring bending die that fits in the bracelet former frame for the hydraulic press. This will allow you to bend heavy gauge ring shanks with ease! TO BE USED WITH THE BRACELET FORMER FRAME (sold separately). 1 inch diameter

Now for bangles too! NEW bracelet forming frame, 2" 95 durometer urethane puck, and set of 4 formers. Please read the information below. Beam: 6"L x 3/4"H Columns: 2 1/2"H x 1 5/8"W (top), 2"W (bottom) Large Synclastic former: 2 7/16"W x 1 3/4"H Small Synclastic former: 1 7/8"W x 1 11/16"H Large Anticlastic former: 2 15/16"W x 1 3/4"H Small Anticlastic former: 1 15/16"W x 1 11/16"H

For use only with Dish Former Silhouette Dies. ~4.75" x 4.75" 60-70 durometer. Color may vary. 1/4" thick.