Impression Die Fancy Ring Shank

This die must be used in a hydraulic press. This die measures 3/16" at the band, 11/16" at the top, and 1 1/2" in length

It is .5" at the widest point on top. The narrow part on the bottom is .25" The length is 1 1/8" Impression dies should be used in a hydraulic press

This spacer is 6''  x  8''  and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use metal pieces on lower platen to take up space between platens.

This die is to make a ring shank that then has a 16mm circle opening to place a stone and bezel. At longest tips it is 3 1/8". Skinniest point is 1/4" H, and tallest points (at ends) is 1 1/4" High.

Pancake Die 648 Art Nouveau Bracelet Link 1" 1/4" x 7/8"