Impression Die Stacked Shield Pendant

This bezel die tool will create as many 6mm round bezels as you'd like to press in your hydraulic press. Recommended for 22 ga. fine silver. The size of disc you start with for the 6mm bezel die is a 12mm disc. The interior bezel height after pressing is ~3mm. You can adjust the height to fit your specific stone.

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.