Impression Die Pebble Rock Ring

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

5/16” x 3 3/16” or 8mm x 81mm Ring Die from Helsinki, Finland. Customer demo: Jada Stahlecker.

This ring band from Michael Ilsa can also make bracelets and patterned earring components. Design: 3/16" x 3-1/8"

This unique ring is perfect for enamel. From Michael Ilsa. Customer demo by Laurie Frost Schutt. Design: 3/16” x 3-5/8”

This tool steel ring pusher will give you greater detail in your rings when used on impression dies in a hydraulic press. Size: 3" x 1-1/2"