(0) items
You have no items in your shopping cart.
All Categories

    Bracelet Die B003A Square Taper 6 1/2"

    6 1/2"W x 1 3/4"H
    SKU: PD B003A

    6 1/2"W x 1 3/4"H

    6 1/2"W x 1 3/4"H

    Customers who bought this item also bought

    Pancake Die 565A Large Rounded Square

    Design: 1 3/8" x 1 3/8" Die itself: 3" x 4 25/32"

    Urethane Pieces

    Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch to 1 inch in length. Thickness of each piece is 1/4 inch.  Note: These will fray, crack and deform with use, but you will get many uses from them.

    6 x 8 Aluminum Spacer

    This spacer is 6''  x  8''  and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use metal pieces on lower platen to take up space between platens.

    Pancake Die B031 Basic Cuff Bracelet

    1.5" H x 6" W. Die itself is 7 7/16" x 4 29/32". Use die sideways in press with extended platens or press about 1/2 the die at a time.

    Pancake Die 511 Large Trillion

    Large Trillion is 1 1/16 inch high and wide (from point to point). This is one of our most popular shapes.