Impression Die Grand Flower of the Sky

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch to 1 inch in length. Thickness of each piece is 1/4 inch.  Note: These will fray, crack and deform with use, but you will get many uses from them.

Perfect for earrings! Left: 2-1/8" x 1/2" each Middle: 1-7/8" x 9/16" each Right: 1-9/16" x 3/8" each Plate Thickness: ~2.5mm

This die must be used in a hydraulic press. Each wing measures 1 1/8" wide x 1 1/4" tall

1/8" x 1/8" or 3mm x 3mm

Properly heat treated hi carbon steel. For use in Stamp Border Holder to push wire into certain ring impression dies.