Close
(0) items
You have no items in your shopping cart.
All Categories
    Filters
    Preferences
    Search

    Wire Die Pusher

    $9.00
    Properly heat treated hi carbon steel. For use in Stamp Border Holder to push wire into certain ring impression dies.
    SKU: Sm Steel plate

    Properly heat treated hi carbon steel. For use in Stamp Border Holder to push wire into certain ring impression dies.

    Won't bend or deform under pressure. Provides even pressure to push wire into certain ring impression dies. Only requires one push rather than repeated pushing, which can make your metal move and produce extra impressions.

    Steel plate is 1.5"H  x 3"W x 1/4" Thick

    Stamp Border Holder with Wire Die Pusher (sold separately)

    Stamp Border Holder with Wire Die Pusher

    Properly heat treated hi carbon steel. For use in Stamp Border Holder to push wire into certain ring impression dies.

    Won't bend or deform under pressure. Provides even pressure to push wire into certain ring impression dies. Only requires one push rather than repeated pushing, which can make your metal move and produce extra impressions.

    Steel plate is 1.5"H  x 3"W x 1/4" Thick

    Stamp Border Holder with Wire Die Pusher (sold separately)

    Stamp Border Holder with Wire Die Pusher

    Customers who bought this item also bought

    Urethane Pieces

    $7.00
    Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch to 1 inch in length. Thickness of each piece is 1/4 inch.  Note: These will fray, crack and deform with use, but you will get many uses from them.

    Tool Steel Pusher

    $55.00
    This is a tool steel pusher used with impression dies and pattern bars.

    Impression Die Thick Rope Band

    $48.00
    1/4" H x 3 1/4"W or 6mm x 82mm This die must be used in a hydraulic press. This design will run off the edge of the die so that you can feed your metal through to make a continuous pattern.

    Impression Die Blank Puck

    $10.00
    Design your own impression die! Made with special die-carving steel that is easy to carve. Use files, gravers, burs, or chasing tools to carve your own design in the negative.

    6 x 8 Aluminum Spacer

    $32.00
    This spacer is 6''  x  8''  and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use metal pieces on lower platen to take up space between platens.