Pancake Die 1150 USA Small

This die must be used in a hydraulic press. This die measures 3/4" tall x 1 2/16"" wide

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

This die must be used in a Hydraulic Press. This die measures 3/4" wide x 3/4" tall

This dainty flower design is used to cut metal blanks in a hydraulic press. Design: 11/16" diameter

This flower is one of the pancake dies that needs deburring on the back after cutting it out with the pancake die with flush cutters. Design: 1.9" diameter